How it works
Put on socks with one hand
Four steps, the same way every time. Position the device, load a compatible sock, slide your toes in first, then guide the sock home with one hand.
How It Works
The same simple sequence each time, from positioning the device to the finished result.
1. Position the Device
Place the Toes First device in the proper position and make sure it is straight and ready to use.
2. Load the Sock
Place a compatible sock over the device and prepare the opening for your foot.
3. Slide Toes First
Slide the sock over your toes as far as possible to your ankle and then rotate the device up to release the sock.
4. Finish Dressing
Use one hand to guide the sock comfortably into place.
The motion
Watch it happen
Placed and straightened
The device sits flat and square so the sock loads evenly every time.
Sock loaded, opening prepared
A compatible sock slides over the device and the opening stays held wide.
Toes go in first
No pinching the sock shut, no chasing the opening with your foot.
One hand guides it home
A single, steady pull finishes the job with far less reaching.
Done
Sock on, seated, without bending down to the floor.
Ready when you are
One Hand. More Independence.
Toes First One-Handed Sock Aid. Made in the USA, shipped from Connecticut, and ready to use straight out of the box.
